Moving Machine By Hand - Husqvarna M-ZT52 Operator's Manual

Moving Machine By Hand

WARNING!
No adjustments or maintenance should
be carried out unless:
• the engine stopped
• the ignition key removed
• the parking brake activated
When pushing or pulling the mower, engage the
bypass linkages with the hydro release levers. The
levers are located on each side of the rear of the unit
below the engine plate.
Raise the deck to the highest (transport) position.
Pull the bypass linkages up and out of the keyhole
slots. Release the lever with the head outside the
bracket and held into the bypass setting.
To reengage the hydro to drive, reverse the above
procedure.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levels are
handled.
34
OPERATION
2
1. Release lever locked into the bypass position
2. Release lever, engaged
Right side, ZT-3400 linkage
WARNING!
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of serious
injury or death if the machine falls off the
ramps.
1
8058-091