Summary of Operating Procedures
Summary of Operating Procedures
To access displays for Honeywell DE Transmitters:
•
Start the MC Toolkit application; the CONNECT TO ... display will appear. (Refer to Figure 8
Start-up - MC Toolkit Application.)
•
Upload the database from the transmitter. (The QUICK MONITOR display will enable viewing of
key parameters before taking the time for database uploading.) The DE MAIN MENU appears. (Refer
to Figure 9 Menu Tree - Honeywell DE Displays in this section.)
•
Select the appropriate display from the DE MAIN MENU. (Refer to Table 3 DE Main Menu
Procedures in this section, and to the list of DE displays .)
The content of each display is summarized in Table 1.
Table 1 DE Displays / Tasks Summary
Menu Item
DEVICE INFO
GENERAL
DE CONFIGURE
CALIBRATION
Page 18
Enter:
Device Type:
•
Tag ID
•
Message (in Scratch Pad)
Select:
•
PV Type
Enter:
•
Comm Mode
•
Line Filter (STT)
•
T/C Fault Detect (STT)
Select:
•
PV Units
•
SV Units
•
Conformity (ST)
•
Damping
•
Sensor Type (STT)
•
Linear
Enter:
•
LRV
•
URV
Enter/Select:
•
Correct Input (Zero)
•
Correct Input (LRV)
•
Correct Input (URV)
•
Reset Corrects (Zero, LRV, URV)
•
Loop Test (Check
•
Trim DAC Current (Calibrate
output current)
•
Apply Values (that is, re-range
LRV and URV to PV input)
34-ST-25-20 MC Toolkit User Manual
Task
Observe (Read):
•
Type
•
Serial Number
•
Firmware Version
Observe (Read):
•
Failsafe Direction
Observe (Read):
•
LRL
•
URL
•
Span
•
Sensor Type (ST)
Observe (Read):
•
Input at Zero, LRV, and URV
•
(Verify) Reset Corrects
•
Loop Current (continuity)
•
Output Current level (at 0 %,
100%)
•
Applied values of LRV and URV
Release 3
9/06