Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Siemens LB 23…
Summary of Contents for Siemens LB 23…
- Page 1 Operating and installation instructions LB 23… LB 54… LB 75…...
-
Page 2: Operating Modes
Operation Instructions Operating modes Exhaust-air mode: Safe operation is possible provided that the underpressure in the room where the The extractor-hood fan extracts the kit- burner is installed does not exceed 4 Pa chen vapours and conveys them (0.04 mbar). through the grease filter into the atmos- This can be achieved if combustion air can phere. -
Page 3: Before Using The First Time
Before using the first time Important notes: Before using your appliance for the first time, please read these Instructions for The Instructions for Use apply to several Use carefully. They contain important versions of this appliance. Accordingly, information concerning your personal you may find descriptions of individual safety as well as on use and care of the features that do not apply to your... -
Page 4: Filters And Maintenance
How to operate the extractor hood Filters and maintenance Various types of grease filter can be The most effective method of remo- used to absorb the grease contained in ving vapours produced during cooking is the vapours produced during cooking. Fleece grease filter Switch the ventilator ON The filter mat is made from material that is... -
Page 5: Metal Grease Filter
Filters and maintenance Metal grease filter 2. Press the retaining spring and remove the filter frame. The filter mat is made of non-combustible metal. Caution: As it becomes more and more saturated with grease, the filter also becomes increasingly inflammable. The efficiency of the extractor hood can also be adversely affected. -
Page 6: Activated Carbon Filter
Filters and maintenance Activated carbon filter Extractor hoods with two filter cartridges: Removing and installing the activa- ted carbon filter Warning: The halogen bulbs must be swit- ched off and cool. Extractor hoods with a filter mat: 1. Depress the detent on the grease filters 1. - Page 7 Activated carbon filter Extractor hoods with two filter cartridges: 5. Insert the activated carbon filter at the rear, fold up and lock in the middle with 1. Remove the filter cartridge. the wing nut. If the spacer rail has been See grease filter.
-
Page 8: Cleaning And Care
Cleaning and care Switch off the extractor hood and isola- Changing the bulbs te by pulling out the mains plug or swit- Candle bulbs: ching off the disconnector on the instal- 1. Switch off the extractor hood and isolate lation side. by pulling out the mains plug or swit- At the same time as you renew the ching off the disconnector on the instal-... - Page 9 Cleaning and care Halogen bulbs: 1. Switch off the extractor hood and isolate by pulling out the mains plug or swit- ching off the disconnector on the instal- lation side. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns.
- Page 10 Installation Instructions: Important information Additional information concerning gas Old appliances are not worthless cookers: rubbish. Valuable raw materials can be reclaimed by recycling old appliances. When installing gas hotplates, comply Before disposing of your old appliance, with the relevant national statutory render it unusable.
-
Page 11: Prior To Installation
Prior to installation Exhaust-air mode If the air intake is inadequate, there is a The exhaust air is discharged upwards risk of poisoning from combustion gases through a ventilation shaft or directly which are drawn back into the room. through the outside wall into the open. An air-intake/exhaust-air wall box by itself is Exhaust air should neither be directed no guarantee that the limiting value will not... -
Page 12: Recirculated Air Mode
Prior to installation Optimum performance of the extractor Extractor hoods with 150 mm Ø air hood: outlet: Short, smooth extraction pipe. 150 mm l extraction pipe As few pipe bends as possible. Screw the reducing connector (see optional accessories on the last page) Largest possible pipe diameter (prefera- onto the air outlet. -
Page 13: Electrical Connection
Electrical connection Installation The extractor hood must be connected to The extractor hood is particularly suitable a correctly installed earthed socket only. for installation in a flue or chimney. Attach the earthed socket as close to the To ensure optimum extraction perfor- appliance as possible and in an accessible mance position. - Page 14 Installation Extractor hood with slide control, 53 cm Extractor hood with slide control, 73 cm wide, 1 and 2-motor: wide, 1 and 2-motor 55 95...
- Page 15 Installation Removal 1. Remove the filter grille (see operating 1. Loosen the screws. instructions). 2. Hold the underside of the extractor 2. Connect the power. hood, Hold the underside of the extrac- tor hood. 3. Press the extractor hood up into the installation opening until the installation Installation spring aid locks into position at the front and...
- Page 16 LZ 23000 LZ 72040 LZ 73040 LZ 73050 461423 481051 095660 9000 018538 Siemens Elektrogeräte GmbH Printed in Germany 0904 Hi.