KitchenAid Instant Hot Installation Instructions And Use And Care Manual page 8

NOTE: Do NOT plug power supply cord into outlet.
8
.Connect l/4" (6.4 mm) spout
Do Not lengthen, twist or tightly
tubing (longer tubing) to the rear
bend tubing.
quick-connect fitting on top of tank.
Push tubing straight into fitting as far
as it will go. Pull on tubing. The
tubing should not come out when
properly installed.
9
n Connect clear tubing from spout
to center tank tubing using clamp.
Make sure clear tubing does not kink.
10
. Install saddle valve following drain line. Drill a l/4" (6.4 mm) hole
kit instructions. If water supply line is into water supply line for the saddle
not copper, shut off water supply and valve piercing pin.
11
.Turn saddle valve handle Place a bucket under open end of
clockwise 0 until lance pierces soft water supply line. Turn on main water
copper tubing and valve is firmly supply valve to pressurize cold water
seated. If the water line is not copper, line. Check for leaks.
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
12
n
Slowly open saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.