Rotisserie; Stainless Steel - GE 36, 48 Use And Care Manual

Stainless
Do not use a steel wool pad; it will scratch the
steel surface.
Inside and outside stainless steel can be
cleaned easily and quickly with a stainless steel
cleaner such as Revere Copper and Stainless
Steel Cleaner® .
Replacing
Before replacing an igniter perform this
simple test.
a rotary
igniter
1. Remove the drip tray.
2. From underneath the valve panel, look
3. Turn the igniter knob. If the igniter is good,
Spider and
Spiders and insects can nest in the burners or
orifices of this or any outdoor gas appliance.
insect
The presence of spiders, spider webs or other
warning
insects can cause the gas to flow from the
front of the burner. This is a very dangerous
condition which can cause a fire to occur
behind the valve panel, damaging the cooking
center and making it unsafe for use.

Rotisserie

Keep the rotisserie motor electric cord away
from the heated surface of the grill. When not
in use remove and store the motor in a dry
location.
Clean the skewer in warm sudsy water.
upwards and locate the end of the igniter
wire where it is connected. Disconnect the
wire and place the metal blade of a
screwdriver about 1/8² from the terminal of
the rotary igniter.
a spark will jump across to the screwdriver. If
there is no spark, replace the igniter.
For hard to clean soil, or film layers of grease,
use a stainless steel cleaner such as Bon-Ami® .
Apply cleaner with a damp sponge, rinse
thoroughly and dry. Always scrub lightly in the
direction of the grain.
If there is a spark, examine the wire of the
electrode for cracks and cuts. Also examine the
electrode for grease and debris or see if the
electrode tip is bent. Is the tip sparking to the
top of the electrode bracket?
The rotary igniter may be replaced from the
front by removing the drip pan and reaching
behind the valve panel to unplug the igniter
wire. Remove the igniter knob and the two
mounting screws. (Reverse the procedure to
replace.) If removing the valve panel is
necessary begin by removing all the control
knobs, then remove the 4 corner screws of the
valve panel.
You should inspect the burners at least once a
year or immediately if any of the following
conditions occur:
1. The smell of gas in conjunction with the
burner flames appearing yellow.
2. The grill or range-top burners do not reach
temperature.
3. The grill or range-top burners heat unevenly.
4. The burners make popping noises.
If blockage exists, clean the burners immediately.
17