Table of Contents
Advertisement
Instructions for upgrading
1
Access on the following website to
issue your password.
http://www.pioneernavigationupdate.com
In Canada:
http://www.pioneernavigationupdate.ca
For issuing the password, follow the instruc-
tion on the website.
2
Record the password that you received.
You need to input this password accurately.
Write down your password to avoid mis-
takes.
Upgrade procedures
NEVER stop the engine of your vehicle or turn
off the power supply to the navigation system
until the installation is completed. Turning the
power off during upgrade process causes a
malfunction or failure of the navigation sys-
tem.
Upgrading the software
program and the map database
This section describes the upgrade proce-
dures for your navigation system.
p The upgrade takes approximately 20 min-
utes in total.
1
Start the engine to boot up the system.
2
Press the MODE button of the AV recei-
ver.
After a short pause, the navigation screen ap-
pears.
p The display will turn off if you press the
MODE button of the AV receiver immedi-
ately after the navigation system restarts, so
wait (approximately 10 seconds) after re-
start before pressing the MODE button.
3
Park your vehicle in a safe place and
apply the parking brake.
4
Insert the upgrade SD memory card
into the SD card slot.
The message confirming whether or not to
start the update will appear.
5
Touch [OK].
6
Touch [Yes].
After a short pause, the keyboard for entering
the password will appear.
# Touch [No].
Shows the device number (Device #) of your navi-
gation system.
# Touch [Cancel].
Cancels the update.
7
Enter the password for authentication
that you obtained, then touch [OK].
A message confirming whether to restart the
navigation system appears.
Chapter
04
21
En
Advertisement
Table of Contents
