Care And Cleaning - GE ZDBT210 Owner's Manual

For your
Unplug the beverage center before cleaning. If the unit is in a built-in location,
remove power at the circuit breaker.
safety
Cleaning The exterior surfaces can be washed with
mild soap and water. Rinse thoroughly
the outside
with clear water. Never use abrasive
scouring powders.
Glass door
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door.
Do not use any abrasive powders.
Avoid cleaning cold glass with hot water
because the extreme temperature
difference may cause it to break. Rough
handling of tempered glass can cause it
to shatter.
Door gasket
The vinyl gasket may be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powder. Rinse well.
Light bulb
Unplug the beverage center before
replacing the light bulb. If the unit is
replacement
in a built-in location, remove power
at the circuit breaker.
In the event
If the power fails, open the door as
infrequently as possible to maintain
of a power
the temperature.
failure
Preparing
Secure all loose items such as shelves and
drawers by taping them securely in place
to move
to prevent damage.

Care and Cleaning

Beverage Center
Do not use scouring pads, powdered
cleaners, bleach or cleaners containing
bleach because these products can scratch
and damage the finish.
Warranty does not cover damage due to
improper cleaning methods.
Do not place magnets on or near the
glass door. Magnets may cause permanent
damage to the door.
After cleaning the door gasket, apply a
thin layer of paraffin wax or petroleum
jelly to the door gasket at the hinge side.
This helps keep the gasket from sticking
and bending out of shape.
To remove the light shield, push in the tab
on the left side of the shield and lower it.
Replace with a 15 watt appliance bulb.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Be sure the beverage center stays in an
upright position during moving.
11