Step 1
Determine
toekick
depth
Step 2
Adjust
movable
base
8
Place a section of the carton on the floor for
protection. Lay the compactor on its back, supporting
it with a piece of wood to prevent pressure on the
power cord.
Measure the toekick of an adjacent cabinet, from
the front of the cabinet door to the front of the
toekick (Dimension A).
Note:
is used, its thickness must be
accounted for in dimension "A".
See step 6.
With the compactor laying on its back, locate the six
Phillips head screws on the bottom, positioned inside
of the movable base.
Loosen these six screws. Slide base to set dimensions
"A" as shown.
Tighten screws making sure base does not move.
Note:
dimension is required, follow the
procedure above and adjust the
base accordingly. The base can be
adjusted from 2-3/4" to 4-1/4" from
the compactor front panel.
Installation
If a custom toekick board
If an alternate toekick depth
Built-In Compactors