Cleaning The Scanner Glass - Brother 891-Z01 Operation Manual

■ Cleaning Inside the Machine
If there are vertical lines or blank areas in the
scanned image, lint or dust may have accumulated
in the machine. The Lint may also attach to the
surface of the feed rollers, preventing a mat to be
loaded or unloaded correctly. Use a soft brush to
clean it.
a
Turn off the machine and disconnect the power
cord plug, and then disconnect the AC adapter
plug from the DC power jack on the back of the
machine.
b
Open the cover on the front of the machine.
c
Remove the holder from the carriage.
d
Use a commercially available brush to clean
around the feed slot and the carriage.

Cleaning the Scanner Glass

If there are unwanted vertical lines in the scanned
image or if scanning cannot be done cleanly, the
scanning area of the scanner may have become
dirty. Clean the scanner glass at the bottom of the
machine.
a
Turn off the machine and disconnect the power
cord plug, and then disconnect the AC adapter
plug from the DC power jack on the back of the
machine.
b
Store away the operation panel.
First raise the panel until it is vertical, and then lower
and store it away.
c
While pushing in the tab at the bottom of the
machine, pull up on the cover.
b
a
59
5