To Set The Starting Time; Cool , Heat , And Fan Only Operation; Dry Operation; Timer Operation - Electrolux R51K/BGE Owner's Manual

COOL , HEAT , and FAN ONLY Operation

1. If the AUTO mode is not comfortable , you may manually override
the settings by using COOL, DRY, HEAT( HEAT PUMP models only),
or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature.
When in COOLING mode, the most comfortable settings are 21 C
or above. When in HEATING mode, the most comfortable settings
are 28 C or b elow.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH,
MED or LOW.
4. Push the ON/OFF button. The operation lamp lights and the air
conditioner starts to operate per your settings. Push the ON/OFF
button again to stop this unit operation.
! !
NOTE
The FAN ONLY mode cannot be used to control the temperature. While
in this mode, only steps 1 3 and 4 may be performed.

DRY OPERATION

1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from
21 C to 2 8 C.
3. Push the ON/OFF button. The operation lamp lights and the air
conditioner starts to operate in the DRY mode. Push the ON/OFF
button again to stop this unit operation.
NOTE
! !
Due to the difference of the set temperature of the unit and the
actual indoor temperature, the Air Conditioner when in DRY mode
will automatically operate many times without running the COOL
and FAN mode.

TIMER OPERATION

PUSH TIMER button to set the on and off times of the unit.

1. To set the STARTING time.

1.1 Please push the CANCEL button to cancel any former settings.
1.2 Push the TIMER button. The remote controller will show the
TIMER and the signal "h" is shown on the display panel. The
control is now ready to reset the TIMER ON to start the operation.
1.3 Push the TEMP button ( or ) to set desired unit START
time .
1.4 After setting the TIMER there will be a one-half second delay
before the remote controller transmits the signal to the Air
Conditioner. Then, after approximately another 2 seconds ,the
set temperature will re-appear on the digital display.
5
TEMP Button : Push the TEMP button to decrease the indoor
1
temperature setting or to adjust the TIMER in a counter-clockwise
direction.
2 MODE Select Button: Each time you push the button, a mode is
selected in a sequence that goes from AUTO COOL DRY
HEAT and FAN as the following figure indicates:
AUTO COOL DRY
NOTE: HEAT feature only for Heat Pump models.
! !
3 SWING Button: Push this switch button to change the louver
angle .
4
ECONOMY Button: Push this button to go into the Energy-Saving
operation mode.
RESET Button: When the RESET button is pushed, all of the current
5
settings are cancelled and the control will return to the initial settings.
DIGITAL DISPLAY Button: Press this button to clear the digit
6
display in the air conditioner, press it again to activate it.
TEMP Button : Push the button to increase the indoor temperature
7
setting or to adjust the TIMER in a clockwise direction.
! !
FAN Button: This button is used for setting Fan Speed in the sequence
8
that goes from AUTO LOW MED to HIGH, then back to Auto.
ON/OFF Button: Push this button to start the unit operation. Push
9
the button again to stop the unit operation.
TIMER Button: This button is used to preset the time ON (start
10
to operate) and the time OFF (turn off the operation).
11
CANCEL Button: Push this button to cancel the TIMER settings.
LOCK Button: Push this button to lock in all the current settings. To
12
release settings, push again.
2
HEAT FAN