Husqvarna

1130ST Owner's Manual page 7

INSTALL CHUTE DEFLECTOR REMOTE CONTROL
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt, flat washer and 5/16-18 locknut
as shown. Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 locknut
as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown.
CHUTE
DEFLECTOR
NYLON
WASHER
CABLE
EYELET
1/4-20
LOCK-
NUT
REMOTE
CABLE
BRACKET
FLAT
WASHER
5/16-18
LOCKNUT
CHUTE DEFLECTOR
CONTROL LEVER
ASSEMBLY
SPRING 1/4-20
SHOULDER
BOLT
5/16-18
CARRIAGE
BOLT
INSTALL WEIGHT BAG
Though seldom required, the weight bag will reduce the
tendency of the auger housing to ride up on hard, icy drifts.
Should conditions require it, install as follows:
1. Shut off engine and wait for all moving parts to stop.
2. Fill weight bag with desired amount of sand.
3. Place weight bag on top of auger housing with mount-
ing clamp at front edge of auger housing as shown.
4. Insert weight bag between the auger housing and the
bar of the mounting clamp as shown and secure with
5/16-18 x 1-1/2 capscrews. Tighten securely.
IMPORTANT: Mount the weight bag in a location which
does not cover the warning decals on top of the auger
housing.
WEIGHT
BAG
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the
factory for shipping purposes. Correct and equal tire
pressure is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
7
MOUNTING
CLAMP
5/16-18 x 1-1/2
CAPSCREWS
AUGER HOUSING
BAR