Table of Contents
Advertisement
Preparation
Signal Connections
Audio and video signals
Audio output
Note 2
Input
Analog audio
DV
RS-232C
REMOTE
Note 1: The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.
Note 2: The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.
When either LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be selected
for input.
When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.
Note 3: When the DVD recorder is in Stop or Recording mode, the video input signal is output on the E-E screen as a composite
video signal.
In addition, the Setup Menu and other setting screens are also displayed on the monitor connected to this terminal. The
DVD recorder's operation status and other relevant information are displayed on-screen when DISPLAY from the DISPLAY
MENU screen has been set to ON.
Note 4: The Y/C IN/OUT terminal's specification (i.e., S1 or S2) can be selected using Y/C TERMINAL MODE from the SYSTEM
MENU (2/2) screen. The same information as with the VIDEO LINE OUT terminal is output from the Y/C OUT terminal.
Note 5: The standard input level for audio signals input via the AUDIO IN terminals (i.e., +4 dB or –8 dB) can be selected using the
AUDIO INPUT LEVEL switch on the rear panel.
Note 6: Use the following cable as the DV cable.
VC-VDV204 (2m, 4P-4P) from JVC
VC-VDV206 (2m, 4P-6P) from JVC
20
Video output
Input
DV
YC separate
Note 4
DV IN/OUT
Y/C IN
MAIN
POWER
Note 6
DV IN/OUT
AC IN
REMOTE cable
Note 1
Composite
Note 3
LINE OUT
Note 4
Y/C OUT
LINE IN
AUDIO OUT
VIDEO
AUDIO
LINE
INPUT
CH1
LEVEL
IN
OUT
+ 4dB
-8dB
Y/C
Y/C
IN
OUT
CH2
FOOT SW
DV IN/OUT
1
2
FOR SERVICE
USB
AUDIO IN
Note 5
USB
Composite
YC separate
Analog audio
REMOTE
PHONES
(on front panel)
Stereo
REMOTE
Keyboard
Monitor TV
Headphones
Advertisement
Table of Contents
