Table of Contents
Advertisement
5.
Type asmc -bmc_ip xxx.xxx.xxx.xxx, then press <Enter> to assign any IP
address to the remote server LAN port. The screen displays the request and
response buffer. Write the remote server IP address in a piece of paper for
reference.
c:\dos>asmc -bmc_ip
Detect System
Detect Motherboard
Detect KCS Interface
New BMC IP : 10.10.10.20
When finished, the utility returns to the DOS prompt.
Make sure that the assigned IP address for both remote and local/central
servers are in the same subnet. You can use the network settings utility in your
OS to check.
6.
Type asmc -bmc_info on the prompt, then press <Enter> to display the BMC
and PET IP and MAC addresses.
Firmware Version : 1.01 (DSBF-D/SAS, DSBF-D, DSBV-D, DSCC-D12/SAS, DSCC-D12,
DSCC-DW
BMC IP
BMC MAC : 00 E0 18 51 10 7A
PET IP
PET MAC : 00 00 00 00 00 00
SOL BAUD: 57600
7.
Restart the remote server, enter the BIOS setup, then boot from the hard disk
drive.
8.
Configure the ASMB3-SOL baud rate (asmc -sol_baud 57600).
Make sure that the ASMB3-SOL baud rate is the same as the Remote Access
baud rate that you previously set in the BIOS. See section "2.4 BIOS remote
console" for details.
.
Adjust the local/central server network settings, if necessary.
2-14
10.10.10.20
: 10.10.10.10
: 00.00.00.00
-> DSBF-D/SAS
-> (DSBF-D/SAS)
Chapter 2: Installation
Advertisement
Table of Contents
