Straight Sewing And Zigzag Sewing; Start Sewing; Change Sewing Direction; Strengthen The Stitches - AEG NM 1600 Instruction Manual

Bedienungsanl.1800/1600 GB

Straight sewing and zigzag sewing

Straight sewing and zigzag sewing
Presser foot: zigzag foot (figure)
Stitch selection:
2 for straight sewing
3-10 for zigzag sewing
Stitch length selection dial: 0.3 – 4

Start sewing

Start sewing
Make sure that both threads are under the pres-
ser foot. While holding the threads with your left
hand, turn the hand wheel into your direction and
put the needle in the position on the material
where you want to start sewing. Lower the pres-
ser foot, step slightly on the foot controller and
start sewing. To bolt the stitch end you have to
sew a few reverse stitches first.

Change sewing direction

Change sewing direction
1. Stop the machine; turn the hand wheel into
your direction to put the needle into the
material. Lift the presser foot.
2. Turn the material in the desired direction.
3. Lower the presser foot and continue sewing.

Strengthen the stitches

Strengthen the stitches
1. Press the reverse button; sew a few reverse
stitches to bolt the stitches.
2. To remove the material you have to take up
the presser foot and to move the material
away into the other direction.
3. The thread cutter is at the backside of the
presser foot.
30.08.2004 17:45 Uhr
1 or
Seite 14
12