Dell Blade System Architecture
Dell Blade System Architecture
Figure 2
Figure 2
1
2
3
4
5
Consider these prerequisites before you install the switch module:
•
•
Cisco Nexus B22 Fabric Extender for Dell Getting Started Guide
4
shows the rear view of the blade chassis, in which you install the switch module.
Rear View of the Blade Chassis
Power Supply Units
Fan Units
Fabric A1
(This is A1 IOM position)
Fabric B1
(This is B1 IOM position)
Fabric C1
(This is C1 IOM position)
Fill any unoccupied interconnect bays or any unoccupied power module bays in the blade chassis
with blanks.
The switch module should be installed into the I/O slot that corresponds to the I/O fabric (A, B,
or C) where a 10GE KR Ethernet Adapter, or 10GE Converged Network Adapter (CNA), within
the blade server, is appropriately installed. The Chassis Management Controller (CMC) GUI can
iKVM
6
Fabric C2
7
(This is C2 IOM position)
Fabric B2
8
(This is B2 IOM position)
Fabric A2
(This is A2 IOM position)
9
Chassis Management Controller (CMC)
(located at the top left and right corner of
10
blade chassis)