For the user ................................34 Description of the Appliance .......................... 35 Extractor version ..............................35 Filter Version ................................. 35 Control Panel - EFC 9460 ..........................36 Control Panel - EFC 9415 ..........................37 Maintenance and care ............................38 Cleaning the hood ..............................38 Metal grease filter ..............................
• When the hood is used in its extractor function, be fitted with a 150mm diameter hose. the following rules must be followed to obtain Only for model EFC 9460 X / 942 120 705: optimal operation: Should there already be a pipe of diameter 125 —...
• The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original ELECTROLUX charcoal filter for this function (Available from your local ELECTROLUX Service Force Centre).
Control Panel - EFC 9460 • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start ON/OFF cooking, you will then get an under pressure in Extractor fan the kitchen.
Control Panel - EFC 9415 • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Warning • Clean the outside of the hood using a damp • Failure to observe the instructions on cleaning cloth and a mild detergent.
• The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original ELECTROLUX charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working Check that: The fan speed is set high enough for the task.
In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local ELECTROLUX Service Force Centre by telephoning: 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk...
Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it.
4 metal screws 3,5 x 9,5 (to affix the deflector to the support) 1 reduction flange Ø 125-120 mm (Only for model EFC 9460 X / 942 120 705) 1 support bracket 5 wood-screws 5 x 45 mm (for wall mounting) 5 wall plugs Ø...
Installation Wall unit mounting - Fig. 10 Disconnect the hood during electrical connection, by turning the home mains switch off. Remove the 2 screws fitted inside the lower part of the hood at the points in which it is fixed to the suction unit (see also operation 3). •...