Turning On The Power Switch - Canon SPEEDLITE 580EX II Instruction Manual

2
Check that the flash is ready.
• The pilot lamp will first turn green (ready
for quick flash), then red (flash ready).
• Pressing the pilot lamp will fire a test
flash.
Turning on the Power Switch
I I , . . . . _ . . . .
1
Set the power switch to
< 0 N
>.
~.
The flash recycling starts.
About Quick Flash
Quick flash enables a flash to be fired before flash-ready, when the pilot
lamp is still green.
Although the Guide No. will be 1/6 to 1/2 that of the full output, quick flash
is effective for near subjects and when you want a shorter recycle time.
Set the drive mode to single shooting. Quick flash cannot be used in the
continuous shooting, FEB, manual flash, and stroboscopic flash modes.
[IJi1
Quick flash can also be used during continuous flash shooting.
(C.Fn-06
~
p.27)
About Auto Power Off
To save battery power, the power will turn off automatically after a
certain period (approx. 1.5 min. to 15 min.) of idle use. To turn on the
Speedlite again, press the camera's shutter button halfway. Or press
the Speed lite's test firing button.
[IJi1
Auto Power Off can also be disabled. (C.Fn-01
~
p.27)
l:il •
A test flash cannot be fired while the camera's operation timer
~4
or
~6
is active.
ill)
The Speedlite's settings will be retained in memory even after the power
is turned off. To retain the Speedlite's settings after you replace the
batteries, turn off the power and replace the batteries within 1 minute.
10