Table of Contents
Advertisement
2.Specification
2.1.2. Weight
SDX-1100V
SDX-1100V/R
2.1.3. Connectors
The SDX-1100V has a SCSI connector with a power connector and Jumpers at the positions shown in Figure 2-3.
All other connectors are for use by Sony's manufacturing and service facilities only.
2.1.3.1. SCSI Cables and Terminators
The Single-Ended SCSI configuration and Low-Voltage-differential SCSI configuration are supported by
SDX-1100V, and SDX-1100V/R The hardware specification of this interface can be found in Clause 3. Physical
Characteristics, of the X3T10/1142D (SCSI Parallel Interface2) standard. Only unshielded connectors are
supported. Possible cable and connector sources are listed below. This does not imply that these are the only
sources for SCSI accessories.
Note: When using high speed data transfer with the SDX-1100V it is recommended that total length of the SCSI
data cable not exceeded 1.5m for Single Ended SCSI configuration. As for Low-Voltage-differential SCSI
configuration, less than 12m is recommended.
Cable
Connector
2.2. Environmental Specifications
The specifications which apply when media is present may be different than these.
2.2.1. Temperature and Humidity Range
Temperature
Operating
Non-Operating(mech.)
Non-Operating(tape)
Humidity
Operating
Non-operating (mech.)
Non-operating (tape)
.
2-4
0.8 kg, without a cassette and a front bezel.
1.1 kg, without a cassette and a front bezel.
Figure 2-3: Connector Positions
SCSI 68 pin Connector
30 AWG Ribbon
Hitachi UL 20848 (or equivalent)
AMP 1-786090-7 (or equivalent)
5 ºC to 40 ºC (ΔT < 10 ºC/h)
-40 ºC to 70 ºC (ΔT < 20 ºC/h)
-40 ºC to 45 ºC (ΔT < 20 ºC/h)
20 to 80% RH, non-condensing
Maximum wet bulb temperature = 26 ºC
5 to 95%RH(ΔRH<30%/h)
Maximum wet bulb temperature = 45 ºC
20 to 80%RH(ΔRH<30%/h)
Jumpers
Power Connector
SONY AIT-5 drive SDX-1100V series Ver. 1.0
Advertisement
Table of Contents
