Electrical Connection; Removing The Appliance; Transportation; Protection Against Frost - Siemens SN25E230EA Instructions For Use Manual

en

Electrical connection

Connect the appliance to an alternating
current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via a correctly
installed socket with protective earth
conductor. See rating plate for required
fusing .
32
The socket must be near the appliance
and freely accessible following
installation.
The connection may be modified
by technicians only.
A power cord extension may be
purchased from customer service only.
Use only a residual-current-operated
circuit-breaker which features the
symbol. Only this extension guarantees
compliance with the currently valid
regulations.

Removing the appliance

Also observe the sequence of worksteps
here.
Disconnect the appliance from
the power supply.
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
Loosen the fastening screws under
the worktop.
If fitted, remove the base panel.
Pull out the appliance, carefully pulling
the hose behind.
24

Transportation

Empty the dishwasher and secure
loose parts.
Drain the appliance according to the
following steps:
Turn on the tap.
Close the door.
Switch on ON/OFF switch
Select programme with the highest
temperature.
The expected programme duration
is indicated on the numerical
display .
5
Press Start button
Programme sequence starts.
After approx. 4 minutes press the
Start button
indicated on the digital display.
After approx. 1 min.
indicated on the digital display.
Switch the appliance off
and turn the tap off.
Transport appliance upright only.
(This prevents residual water from
running into the machine control and
damaging the programme sequence.)

Protection against frost

If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely
(see Transportation).
Turn off the tap, disconnect supply hose
and drain water.
.
1
.
4
until is
4
is
1