Canon MP980 series On-Screen Manual page 673

Printing from DVD/CD Label
> Printing on DVD/CDs
Advanced Guide
Printing from DVD/CD Label
Copy the label of an existing DVD/CD and print it on a printable DVD/CD.
Important
You cannot print on 8 cm DVD/CDs.
Note
If printing is misaligned, adjust the printing position. For information on how to adjust it, see
Adjusting the Print Area
1.
Make sure that the machine is turned on.
2.
DVD/CD label print on the HOME screen, then press the OK button.
Select
3.
From DVD/CD label, then press the OK button.
Select
The print area setting screen is displayed.
4.
button to select Outer circle or Inner circle and use the
Use the or
button to change the print area.
5.
Press the OK button.
Note
Measure the outer and inner diameters of the printing surface of the printable DVD/CD and
make sure you set a value smaller than the measured value for the outer diameter, and a value
larger than the measured value for the inner diameter.
For information on printable discs, contact their manufacturers.
6.
Use the or button to select Recommended DVD/CD or Other DVD/CD, then
press the OK button.
Note
If your medium is the recommended DVD or CD, specify Recommended DVD/CD for the
suitable density printing. If not, specify Other DVD/CD.
7.
Load the copy source DVD/CD on the Platen Glass, then press the OK button.
Important
Be sure to load the copy source DVD/CD with its label side down on the center of the Platen
Glass. If you load it near the edge of the Platen Glass, part of the image may be cut off.
8.
Check the print settings, then press the OK button.
The message for preparation is displayed.
Note
Press the Black button for black & white copying.
To change print settings, press the Back button repeatedly until the screen for the setting item
to change appears, then change the setting.
Important
Do not see the light source directly while copying is in progress.
> Printing on the Label Side of DVD/CDs
.
> Printing from DVD/CD Label
or
Page 673 of 947 pages