Table of Contents
Advertisement
20
en | User Information
keyboard remains inactive for about five seconds, the camera display returns to default mode
and again displays the camera number. The third mode is for error display (refer to Error
Messages). When the operator enters an erroneous key sequence, the keyboard beeps and an
error number is temporarily displayed (for approximately 2 seconds).
7
User Information
7.1
General
The Allegiant system is factory-supplied with various user-selectable features set to their
default states (the main Allegiant system Installation Manual contains complete descriptions).
Since these features are user-selectable and have a significant effect on system behavior,
some of the descriptions below may not apply to your system configuration.
7.2
Keyboard Login Procedure
Two modes of keyboard access exist. The factory default settings, allow the keyboard to be
used as soon as it is connected to an operating Allegiant system. The second mode requires
operators to logon to the keyboard before access to the system is permitted. A valid User
number and password are required. If the login feature is being used, the system installer or
administrator typically provides this information to all operators requiring system access.
Perform the following steps to login to the keyboard:
1.
2.
3.
4.
5.
6.
7.
8.
9.
7.3
Keyboard Log Off Procedure
If the logon feature is not enabled, it will not be possible to log off the keyboard. If the feature
has been enabled and you are currently logged on, press USER, then press OFF. The logged
off keyboard displays flashing dashes in the keyboard LED display.
F.01U.127.290 | 2.0 | 2009.03
If the keyboard is displaying a camera and monitor number, it is already logged on; no
action is required. When the keyboard is in a logged off state, the left side LEDs display 3
flashing dashes.
Press ON. A 'U' should appear in the LED display as a prompt for entering a User number.
Enter your User number via the numeric keypad, then press ENTER. Up to 32 user
numbers are available (128 for Allegiant LTC 8900 models).
If the entry is incorrect, press CLEAR and repeat the above step.
Press ENTER.
Verify that the keyboard monitor display now shows a 'P'.
Enter the password (maximum of six digits). The keyboard camera display indicates the
number of digits entered, but not the actual password. Press ENTER when finished
entering the user password.
If the User number or password is invalid, the display returns to the flashing dashes
mode.
If the User number and password are valid, you will be logged onto the system. The
keyboard's LEDs now indicate a monitor and camera currently under control by the
keyboard.
Example: ON 12 ENTER 123456 ENTER
This example shows User #12 with password #123456 logging onto the system.
Instruction Manual
Allegiant Keyboards
Bosch Security Systems, Inc.
Hide quick links:
Advertisement
Table of Contents
