Sharp MD-MS200W Service Manual page 39

• Test mode check
Insert a high reflection (low reflection) disc, and once perform automatic adjustment in AUTO mode, and then check in MANUAL mode.
Simultaneously observe waveforms of EFM(TP145), FEOUT(TP143), and TEOUT(TP144).
Does the optical pickup move to outer/inner periphery when
the / button is pressed?
Is tracking error offset measurement within allowable range?
Is focus error offset measurement within allowable range?
Is laser power normal when laser lights?
Does focus access occur in focus gain rough adjustment
step?
Is adjustment out of allowable range?
Does the disc motor rotate in the same step?
Is focus servo applied in tracking gain adjustment step?
Doesn't the disc motor rotate at high speed in the same step?
Is tracking gain adjustment within allowable range in the
same step?
Is adjustment within allowable range in tracking error
balance adjustment step?
Is tracking servo applied in focus gain fine adjustment step?
Is slide servo applied in continuous playback step?
Is cluster address counted up continuously in the same step?
Continued on the next page.
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
MD-MS200W/MD-MS200/MD-MS200H
Check the pins 56 and 57 of IC201, the pins 25, 27, 29 and 30
No
of IC601, the pins 10 and 11 of CNS601, and the slide motor
terminal.
Check Vref values of pins 3 and 4 of IC101 and pin 22 of IC201.
No
Check Vref values of pins 3 and 4 of IC101 and pin 22 of IC201.
No
Check the pins 21 and 22 of IC101, the pins 6 and 52 of IC401,
No
the periphery of Q101, Q102, and Q103, CNS101, and pickup
flexible PWB insertion.
Check the pins 52 and 53 of IC201, the pins 10, 12, 14, and 15
No
of IC601,and the pins 5 and 7 of CNS101.
Check whether values of pins 10, 11, 14, and 15 of IC201, pins
No
30 and 32 of (IC101) (TP143) change when the
is pressed.
Check as stated in item "The disc motor does not rotate".
No
Check timing of pins 91 and 92 of IC401 and TP144(TEOUT).
No
Check EFM waveform of pin 23 of IC201 in case of high
reflection.
No
Check ADIP waveform of pin 4 of IC201 in case of low reflection.
Check whether values of pins 16 to 19 of IC201 and
No
TP144(TEOUT) change when the
Check whether value of pin 20 of IC201 and TP144(TEOUT)
No
changes or DC shift occurs when the
pressed.
Check waveforms of pins 54 and 55 of IC201, pins 18, 19, 21,
No
and 23 of IC601, pins 4 and 6 of CNS101.
Replace IC201.
No
Check waveforms of pins 53 to 56 of IC101 and pins 23 to 25 of
No
IC201. (In case of low reflection check also the waveform of pin
4 of IC201.)
– 39 –
/ button
/ button is pressed.
/ button is