Initialization Error Codes - Nokia A032 Getting Started Manual

Initialization error codes

Note: If the unit fails
to perform the
initialization
sequence, it may need
to be repaired. In this
case contact your
supplier for support.
Code
100001
110000
110001
110010
110011
110100
001000
001001
001010
101000
011000
011001
011010
011011
34
If the initialization procedure fails an error
code will be displayed on the
LED will remain on.
alert
The code reads from left to right. To identify
the code write down each LED as a '1' or '0' (on
= 1). For example the pattern:
on on off off on off
would be written:
110010
The following table shows the error codes.
Meaning
Bad code image
Bad PCMCIA hardware
No PCMCIA
Bad PCMCIA card
Bad radio (does not initialize)
Bad firmware version
Bad DRAM (stuck address)
Bad Ethernet RAM (stuck address) Memory error type 2
Bad CMOS Memory
LAN controller error
Bad configuration
Bad Manufacturer's info
Bad log sector
System error
Troubleshooting in the Advanced User Guide
gives a more detailed explanation of the above
error messages.
LEDs and the
info
Log text
<none>
PCMCIA hardware failure
No PCMCIA card detected
Non-compatible PCMCIA card
Cannot initialize radio
Incorrect firmware version
Memory error type 1
Config. error — default loaded
LAN Interface Error
Configuration error
Bad unit checksum
Log sector bad — recovered
System fault
Nokia A032 Getting Started