NEC SoundStation IP 7000 Quick Start Manual page 21

After you connect an auxiliary audio component to the Multi-Interface
Module, you must enable the component. To enable the component, see
the User Guide for the Polycom SoundStation IP 7000 Phone, available at
www.necunified.com.
Note You do not have to enable audio from a mobile phone or from a computer calling
application. This audio is automatically enabled when you connect the
Mobile Phone Cable or the Computer Calling Cable to the 2.5mm audio connector
on your conference phone.
2.5mm Audio Connector on Phone
Your conference phone has a 2.5mm audio connector to connect to a mobile
phone or to a computer calling application. You connect a mobile phone or
computer calling application so you can use the conference phone speaker to
stream two-way audio from the mobile phone or computer calling application
for hands-free conversations. When you connect mobile or computer audio to
your conference phone, all participants in a call or conference call (including
those connected through a mobile phone or computer calling application) can
hear and speak to each other.
The 2.5mm audio connector is located on the right-side of your conference
phone, behind a door you flip open.
The following figure shows the 2.5mm audio connector on the side of the
conference phone. The 2.5mm audio connector has a mobile phone icon above
it.
Setting Up Your Phone
1 - 13