Frigidaire Cleveland CMSF-1/0310 Important Instructions & Operating Manual page 6

For service questions, please contact Frigidaire at 1-800-944-9044.
For sales inquiries, please contact Sylvane at 1-800-934-9194 or visit www.sylvane.com.
Replacing the Light Bulb
•
This fireplace consists of 2 bulbs (E-12, 40W) that illuminate a flame effect. The light bulbs need
to be replaced if you notice a dark section of the flame or when the flames lose clarity.
• Warning - Always disconnect from the power outlet before removing bulbs to reduce the risk of
fire, electric shock or damage to property.
•
Warning - The bulb reaches high temperatures during operation. Allow it to cool down before
replacing it.
•
Access the bulb panel located on the rear panel of the fireplace (see figure below).
• Access the bulb by removing the four screws located on the back panel.
•
Replace the bulb with a new one. Extra caution should be taken because the bulb can be hot.
•
Close the panel lid using screws.
•
Warning – Do not use fireplace without properly putting the lid back in place.
Cleaning & Maintenance
•
Disconnect from the power supply before attempting any maintenance or cleaning in order to
reduce the risk of fire, electric shock to persons or damage to property.
•
Warning - Always disconnect from the power supply before cleaning fireplace.
• For general cleaning, use a soft, clean duster. Never use abrasive cleaners. The glass viewing
screen should be cleaned thoroughly with a soft cloth. Do NOT use proprietary glass cleaners.
Technical Specification
•
Supply: 110-120V, 60Hz
• Rated Power: 1500W
•
Bulb: 2 x 40W E12
6