JVC GC-XA1 Detailed User Manual page 45

The LCD shows [Connecting
Failed] after pressing WiFi
Button.
The WiVideo program cannot be
installed.
Wi-Fi connections break off.
Connecting a USB cable stops
photography. Photography is
not possible with a USB cable
connected.
There is no HDMI output.
The thermometer icon appears.
• The password configuration does not match to the AP you
want to connect.
• The AP router or the computer is not turned on. Turn the AP
router or your computer on.
• The camera is not in the wireless network service area or
weak network signal. Please make sure the AP router is able
to access the Internet.
• The camera does not support the type of encryption used on
the AP. This model only supports WEP/WPA/WPA2 personal
type of encryption, but not up to enterprise level.
• Your network requires PPPoE account/password information.
• Some AP routers do not allow you to connect to the network
(e.g. firewall).
• The social websites update their websites without notice.
Please visit the website first to update your account setting or
upgrade the firmware and WiVideo program.
• Check the computer system compatibility.
• The camera disables any Wi-Fi connection three minutes after
shooting starts. Use the menu to re-enable it. Reconnect in a
clear radio environment. Remember that the communication
speed drops, interfering with connection, if the receiver is too far
away, there is something in between blocking communications,
or there is a microwave or wireless equipment in use nearby.
• Only time lapse and endless recording are available with a
USB cable connected. (Endless recording is limited to 720p
30 fps.)
• HDMI output is disabled during recording.
• Turn off the camera and allow it time to cool down.
45
EN