Mobile Home Installation; Unpacking; Reversing Door Swing - Kenmore 41798076701 Installation Instructions Manual

MOBILE HOME INSTALLATION
1. Dryer MUSTbe exhausted outside (outdoors, not beneath the
mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath the
mobile home isenclosed, the exhaust system MUSTterminate
outside the enclosure with the termination securely fastened
to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to be
not less than twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 346764 is available from your dealer.
5. Refer to pages 2 and 3 for other important venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which isa Federal Regulation
Title 24 CFR-Part 32-80) or when such standard is not
applicable, with American National Standard for Mobile Homes.
The dryer isdesigned under ANSI Z 21.5.1 or ANSI/
UL21 58 - CAN/CSA C22.2 (latest editions) for HOME USE only.
,
UNPACKING
Using the four shipping carton corner posts (two on each side),
carefully lay the dryer on its left side and remove the foam
shipping base.
To prevent damage, do not use the control
panel as a means to pick up or move the dryer.
2. Return the dryer to an upright position.
FOAM
SHiPPiNG
PAD
PACKING
DO
DON'T
O
Correct
Incorrect
DO
Correct
DON'T
Incorrect