Audio Output; Dtv Connection - Haier HL40B Owner's Manual

External Equipment Connections

DTV connection

- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV`s (Y, P , P ) , VGA or HDMI
B R
jack for video connections, depending on
your set-top box connector. Then, make
the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer
to the owner`s manual for the digital
set-top box.)
2. Use INPUT on the remote control to select
YPbPr, VGA,or HDMI source.
Signal YPbPr
480i Yes
480p Yes
720p Yes
1080i Yes

Audio Output

Send the TV`s audio to external audio equipment (stereo system) via
the Audio Output (Optical) port.
How to connect
1. Connect one end of an optical cable to the TV Audio (Optical)
Output port.
2. Connect the other end of the optical cable to the digital audio (optical)
input on the audio equipment.
See the external audio equipment instruction manual for operation.
Note: When connecting with external audio equipments, such as
amplifers or speakers, please turn the TV speakers off.
Caution: Do not look into the optical output port.
Looking at the laser beam may damage
your vision.
12 TV LCD-TFT
PC
HDMI/DVI
Yes
Yes
Yes
Yes
AV OUT L
Y2 Pb2 Pr2 L R
Y1 L R S-VIDEO
Pb1 Pr1
Digital Set-top Box
R
HDMI1
VIDEO L R
PC/DVI
OPTICAL
AUDIO IN
Installation
PC/DVI
OPTICAL
AUDIO IN
AC IN