Table of Contents
Advertisement
INSTALLATION
WITH OTHER
COOKTOPS
WHERE
SPECIFIED
Figure 8
B. FOR INSTALLATION
WITH ANOTHER
BRAND OF COOKTOP
(Figure 8)
Have the following cooktop measurements available before
proceeding All cooktop dimensions should be verified
through measurement prior to cutting the countertop:
CCW = Cooktop Cutout Width
CCD = Cooktop Cutout Depth
COW = Cooktop Overall Width
COD = Cooktop Overall Depth
with the above dimensions confirmed, determine the cutout
size as follows:
1.
Find the cutout width,
(CW):
if CCW is smaller than the UCV cutout width then:
Installation
CW
DHD8005UC
283/8
DHD9605UC
34s/s
if CCW is Jarger than the UCV cutout width then:
CW = CCW
See Figure 8 for UCV cutout widths and dimension
definitions.
2.
Calculate
the cutout
depth, CD:
Determine the cooktop overhang (CO)
CO = (COD-CCD)/2 (Assumes front and rear cooktop
overhangs are equal) Calculate the cutout depth, (CD):
CD = COD - CO+lz7/s ''
3.
Determine
setback
(SB} distance
from front of
countertop
to front of cutout. SB is specified in the
installation instructions shipped with the cooktop.
4.
Backsp_ash thickness
must not exceed BT as
calculated
below:
BT = 24 7/s" z OD-SB+CO
(Provides 1/s"clearance between vent and backsplash.)
A negative value for BT means countertop is too small
for the installation.
5.
Verify that the available flat countertop has a width
greater than OW and a depth greater than OD.
OW depends
on the installation:
DHD8005UC: OW equals the greater of COW or 30".
DHD96005UC: OW equals the greater of COW or 36".
OD is determined by: OD=COD+21/s ''
6.
Cut countertop
using dims: CD, CW and SB as
defined in Figure 8.
Page 8
Advertisement
Table of Contents
