6 (30" models) or :[2 (36" models) Blunt-Nosed CANNOT be substituted. Sheetmetal Screws This unit is approved for use with all residential appliances. For residential use only. Note: The Bosch ventilation hood referred to throughout this manual is manufactured by BSH Home Appliances Corporation.
Page 3
Consequently, Bosch Blower Cord Connector recommends the hood be installed 30"-36" above the countertop. Remote blowers require a five wire installation. Connector Access Panel Make-Up Air: Local building codes may require the use of make-up air systems when using ducted ventilation systems greater than specified CFM of air movement.
Page 4
are :[5 3/4" from the center line (See Figure 5). nstall Transition Place the hood. For i_ternai bJower installation, install the 7" Tighten the screws, transition (included) to connect to 7" ducting. If 7" ducting is not available, 8" ducting may be used. In this instance, an additional 7=8"...
Accessories Connect Wiring The following accessories are available from your Bosch WARMING: dealer or through Bosch Service: 800-944-2904. Please Use only spring type wire nuts (included) to make reference the model number when requesting these items. electrical connections. Replacement wire nuts must be...