Wall-Vented Installation - Bosch HMV9302 Installation Instructions Manual

STEP 3:
PREPARE THE VENTING BLOWER
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and one blower
plate screw. Remove the blower plate from cabinet.
See Figure 13.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
"B" from Back plate. Discard knockouts. Be careful net
to distort the plate. See Figure 14.
4. Reassemble the blower wire. See Figure 15.
5. Rotate the unit so that the exhaust ports face the rear of
the cabinet. See Figure 16. When you insert blower unit,
blower wire must be like Figure 16.
6. Place blower unit back into cabinet. Check that the
exhaust ports face towards the rear of the cabinet.
See Figure 17.
7. Reattach the blower plate to cabinet so the exhaust ports
and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one blower plate
mounting screw. See Figure 18.
Figure 15
blower unit
back plate
blower plate
mounting screws
"_.\
blower unit
{Option> mounting screw
Figure 13
Parts "B"
Figure 14
Figure 16
blower
unit
exhaust
ports
11