Step 5: Install 90 ° Elbow; Step 6: Install Drain Hose To Drain Loop; Step 7: Position Water Line And House Wiring; Step 8: Install Drain Hose, Through Cabinet - GE GDT550HGD0BB Installation Instructions Manual

Dishwasher Installation
STEP 5: INSTALL 90 ° ELBOW
• Wrap a 90 ° elbow with
thread seal tape.
• Thread 90 ° elbow
Water Valve
onto the water valve.
Bracket
• Do not overtighten
elbow. Water valve
bracket could
bend or water valve
fitting could break.
Thread.
• Position the end of Seal
the elbow to face the Tape
rear of the dishwasher.
Figure K
Front of Dishwasher
_90 ° Elbow
Fill Hose
STEP 6: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp as
shown in the figure.
Figure L
STEP 7: POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the floor of the
opening to avoid interference with base of dishwasher and
components under dishwasher.
--Water
Line Wiring
Figure M
STEP 8: INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
Maximum Drain Hose
Length 10'
Insulatiol
Blanket
Hose
/'
House
Wiring
Power Cord
(if Used)
Figure N
Tip: Prevent unnecessarg service call charges for fill, drain or
noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.