Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[] []
[]
[]
[] []
[] []
[]
[]
[] [] or []
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
• CAUTION
-
Unplug the
Refrigerator.
To eliminate
the danger
_]_
of electric
shock during
installation,
it
I
you must unplug
the refrigerator
from
\\
its electrical
outlet.
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharpknife
5116"Nutdriver
[] REMOVE
THE COVER
At the bottom
rear of the refrigerator,
remove
the
screw(s)
holding
the compressor
compartment
cover (if covered)
and save for reinstallation
later.
Bend the cover back for access to the compartment.
[] AI-rACH THE WATER VALVE
• Locate the female connector plug (A) which is
attached
to the cabinet
with a wire tie. Remove
the wire tie and discard
it.
Wiretie
• Remove and discard the tape from the female
connector
(A) and plug onto the male terminals
on the water valve (4). Either
wire can go on
either terminal.
• Fasten the water valve to the cabinet
edge hole
using the hex-head
screw (13) from the kit.
DO NOT DRILL ANYADDITIONAL
HOLES.
• Check
the plastic water line nut on the bottom
of the water valve to be sure it is hand
tight.
DO NOT USE TOOLS.
12
Advertisement
