Outside Back Exhaust; Remove Exhaust Adaptor; Attach Mounting Plate To Wall - GE JVM1660CB007 Installation Instructions Manual

Installation Instructions
OUTSIDE BACK EXHAUST
(Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Exhaust Adaptor
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
BS. Adjust Blower
B6. Mount the Microwave Oven
|
I-_ PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
• Read the insuucfions on the REAR X_SkLL
TEMPIATE.
• Tape it to the rear wall, lining tap with the holes
previously drilled for holes A and B in the wall
plate.
• Gut the opening, following the instructions of the
REAR X_SkLLTEMPLATE.
I-_ REMOVE EXHAUST ADAPTOR
This microwave oven is shipped assembled for top
exhaust. You will need the exhaust adaptor for
installation in the rear wall opening. To remove the
exhaust adaptor from the microwave oven:
Remove rope securing dampm.
Lift off the
Remove and blower plate
save screw _ _ and attached
• " uamper
that holds "_, / adaptor fiom
blower plate ;..._/, / the microwave.
to microwave; ..... _,,_,.,,
......... i...."..
°" i
_ Backof
..... -..... Microwave
_ Slide exhaust adaptor to one side and remove it.
15