Table of Contents
Advertisement
INSTALL DUCTWORK
CAUTBON
- BEFORE
CUTTING
HOLE IN CABINET
FOR DUCT-
WORK." Check for interference
with floor joists, wal! studs, electri-
cal wiring
or plumbing.
WIRING DIAGRAM
120 VAC
MNE _N
3-1/4" X 10"
TO 6" RD
TRANSmON
6" RD
ELBOW &
DUCT-
1. Cut
hole
in cabinet
as we!l
as
holes
in wall
or floor
as
necessary.
2.
Mount the roof or wall cap and work back towards
the cabinet,
attaching
al! ductwork,
elbows
and transitions
as previously
planned.
Tape al! ductwork
connections
to make them secure
and air tight.
3.
Connect
ductwork
(and transition,
if required)
to downdraft.
If
necessary,
LOOSEN
nuts and screws
that hold the blower
in
place,
and slide
blower
left or right
to meet
ductwork.
Re-
tighten
screws
and nuts.
Note:
A 3-1/4"
x 10" collar is provided
for insta!lers
who prefer to
rivet the ductwork
to the unit. This will allow blower
to be removed
and replaced
easily
in service
situations
without
disturbing
duct-
work.
INSTALL ELECTRICAL WIRING
INSTALL COOKTOP
1. Align
the cooktop
with
the downdraft
and fasten
cooktop
in
place.
Note: Accurate
alignment
of cooktop
and downdraft
is necessary
to ensure
that there is no interference
when air vent is raised and
lowered.
There should
be a gap of 1/32"-1/16"
between
the back
of the cooktop
and the front of the downdraft
cover.
ADJUSTMENT
The downdraft
is factory-adjusted
for proper operation.
However,
shipping
and handling
may affect
the position
of the activating
switch.
To adjust
position
of activating
switch:
1. If downdraft
is plugged
into electrical
outlet,
unplug
it.
2.
Lift air vent straight
up and cock it slightly
so it remains
in the
UP position.
1. Mount
a standard
wiring
box,
with
%pronged
receptacle,
inside the cabinet.
Make sure the downdraft's
power cord can
easily
reach
it.
2.
Run appropriate
power
cable into cabinet
and connect
it to
receptacle.
3.
Plug the downdraft's
power
cord
into the outlet.
SWITCH
MEMBRANE
3.
Remove
switch
cover from right end of air vent.
4.
Loosen
the 2 screws
holding
the switch
bracket
in place.
Position
switch
bracket
so that activating
switch just comes
in
contact
with underside
of switch
membrane.
Tighten
screws.
5.
Replace
switch
cover,
gently lower air vent into chimney,
and
plug in power
cord.
Re-connect
electrical
power
and check
operation.
Advertisement
Table of Contents
