Page 1
Full Size Tumble Action Washers Before beginning installation, carefully read these instructions_ This will simplify installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future references NOTE: The electrical service to the washer must conform with...
Page 2
absence of local codes, with tile National Electrical PRE-INSTALLATION REQUIREMENTS Codes, ANS!/NFPA 70 (latest edition). If in doubt, call a licensed electrkian. DO NOTcut off or alter Tools Required for InstMladon: the grounding prong on the power supply cord. In 1.
Page 3
ROUGH-fN DfMENSfONS 27.75 ( 7o.5 ) ...... -: 24" 6 O" (6_) (152.4) Power Cord 33.40 SIDE (68,6) 6.75" (17,1) Water Inlets 2,75' 33,5' Draln 32.25" BACK...
Page 4
Remove the following from the back panel of the LOCATION OF YOUR WASHER washer: 4 packaging bolts, DO NOT INSTALL YOUR WASHER: 2 packaging springs, In an area exposed to dripping water or outside 2 washers, weather conditions. Tile ambient temperature 2 metal "P"...
Page 5
INSTALLATION STOP ° DRAZR HOSE TABS Run some water from the hot and cold faucets to flush the •'\,\\ water lines and remove SPRZNG CLAMP particles that might clog up PROVIDED the water valve screens. HOSE Remove the inlet hoses and rubber washers from tile plastic bag located in the drum...
Page 6
I_800_944_9044, visit website, www.frigidaire.com, for the Frigidaire Company Authorized Parts Distributor nearest you. [_ W_y±_'_,ll_LqDestroy the carton and plastic bags after the washer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads, or plastic...