Frigidaire CFGS379DC2 Installation Instructions Manual

30" gas slide-in range with sealed top burners

Advertisement

Available languages

Available languages

Quick Links

INSTALLATION
AND SERVICE MUST BE PERFORMED BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
if the information
in this manual is not foIlowed
exactly,
a fire or explosion
may result causing
property
damage, personal injury or death,
FOR YOUR SAFETY:
--
Do not store or use gasoline or other flammable
vapors and liquids in the v[dnity
of
E
0
0
0
0
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical
switch;
do not use any phone in your building.
Immediately
call your gas supplier from a neighbor's
phone.
Follow the gas supp[[er's
instructions.
If you cannot reach your gas supplier, ca[[ the fire department,
Installation
and servke must be performed
by a qualified
installer,
servke agency or the gas supplier.
Do not pinch the power supply cord or
the flexible gas conduit between the
range and the wall
Do not seal the range to the side
cabinets
*NOTE: 30" (762 cm) minimum
clearance between the cooktop and the
bottom of the cabinet when the bottom
of wood or metal cabinet is protected by
not lessthan Y4" (064 cm) flame
retardant mi[Iboard covered with not Jess
than No_ 28 MSG sheet metal,
0015 "(0.4 ram) stainless steel,
0.024"(0.6
ram) aluminum, or 0020"
(0_5 ram) copper_
36" (91 _4 cm) minimum clearance when
the cabinet is unprotected
NOTE:
Allow at least
19 ¼" (48.9
cm) cbarance
_
for door
depth when it
m open.
Shave Raised Edge to
Clear 31 I/2"
(81 cm)
Wide Cooktop Rim,
I Y2" Max
(3.8 cm) Max
Locate Cabinet_
Doors I" (2.5 cm)
Min. from Cutout
Opening
30"
Mill*
I*
(17:8 cm Min.)
_
30" Min*
Fl'orn Wall Both
_< (762 crn) Min*
Sides
18" Min.
(45.7 cm) Min
Right side wall
I from front
Note:
For 29" (73.7 cm) cutout
(6I cln)Min
wide
opening,
you must
call your
dealer,
installing
agent
or authorized
servker
to purchase
optional
side panels
:_0" x 12"
i 5/16" (see figure
on left corner)
and dear
wide
(76.2cm X
Recommended area for
.SL33crN cooktop
rim as shown
in the "Counter-
so.scm)
wall connection of manual
Recommended shut off valve (outside the
/
top
Preparation"
section
(see page 3}.
area for electrical
cut-out area as
wall oulet,
mentionned on page 4)
Door Open
(see note)
panel
**
For cutouts
below
22 7/8"(581
cm), appliance
will slightly
show
out of the cabinet.
22 7/8" **
***
IMPORTANT:
For width
cutout
(F dimension)
more
(58.1 cm) rain.
than
30 1/16"
(76.4
cm) to avoid
damage
to the
i÷ 23 1/4
....
-_1
(59
05 cIT_) t_ax
cooktop,
make
sure the appliance
is centered
in the
_
_1
counter
opening
while
pushing
into
it, Raise leveling
legs
kl
........
J
1 I/8
at maximum
position,
insert
the appliance
in the counter
_
b_I_Ic/8_:',,,
J
I
and then
level.
Make
sure the unit
is supported
by the
FRONT [ _ ........
'
[
[
G
leveling
legs and not by the cookto
_ itself.
OF
_
Ref. 1
[
Figure 1
CABINET[
'
I
A
HEIGHT
B,WIDTH
C, DEPTHTO
F,CUTOUT
H, HEIGHTOF
[
FRC)NT OF RANGE
WIDTH ***
£OUNTERTOP
35 318" (90 cm - 36 318" (92 cm
30" (76,2 cm)
28 5/16" (71,9 cm
(76,2±0,I30±1116"5
cm
2122 3 14"i/8. (55,2(56,2
cm)cm M in,Max 36"35 318"@1'4(90Cm)cm)Standardn'f
G Minimum
Cutout
Depth is increased
to 24"(61
cm) with
backguard.
P/N 318201668
(0411)
Rev B
NOTE: Wiring
diagram
for these
appliances
are enclosed
in this
booklet.
English - pages 1-9
Printed in United States
Francais - pages 10-18
Wiring Diagrams-
pages 19-20

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire CFGS379DC2

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. if the information in this manual is not foIlowed exactly, a fire or explosion may result causing property damage, personal injury or death, FOR YOUR SAFETY:...
  • Page 2: Important Safety In

    Make sure the wall coverings around the range Important Notes to the Installer can withstand the heat generated by the range. Read all instructions contained in these installation • Do not obstruct the flow of combustion air at the instructions before installing range. oven vent nor around...
  • Page 3: Cabinet Construction

    Cabinet Construction Provide an adequate Gas Supply When shipped from the factory, this unit is designed to To eliminate the risk of burns or fire by operate on 4"(10,16 cm) water column (!.0 kPa) Natural reaching over heated surface units, do not have cabinet gas manifold pressure.
  • Page 4 Connection to Pressure Regulator The regulator is already installed on the appliance. Do not make the connection too tight. The regulator is die cast. Overtightening may crack the regulator resulting in a gas leak and possible fire or explosion. Manual GAS FLOW Pressure Shutoff...
  • Page 5: Electrical Requirements

    Where a standard 2-prong wall receptacle is installed, it LPiPropane Gas Conversion is the personal responsibility and obligation of the This appliance can be used with Natural gas or LP/ consumer to have it replaced by a properly grounded 3- Propane gas.
  • Page 6: Check Operation

    Installation With Backguard Range JnstaJJation Tile cutout depth of (21 3/4" (55.2 cm) Min., 22 1/8" Standard JnstaJJation (56.2 cm) Max.) needs to be increased to 24"(10,16 1. The range cooktop overlaps the countertop at the (61 cm) when installing a backguard. sides and the range rests on the floor.
  • Page 7 9.2 Turn on Electrical Power and Open Main 9.5 Operation of Oven Burners and Oven Shutoff Gas Valve Adjustments 9.5.1 Electric Ignition Burners Operation of electric: igniters should be checked after 9.3 Check Igniters range and supply line connectors have been carefully Operation of electric igniters should be checked after checked for leaks, and range has been connected to range and supply line connectors have been carefully...
  • Page 8: Leveling The Range

    9,5,2 Air Shutter-Oven B urner Leveling the Range Level the range and set cooktop height before installation in the cut-out opening. 1. Install an oven rack in the center of the oven. 2. Place a level on the rack (see figure 13). Take 2 //"...
  • Page 9 Unfold paper template and place it flat on the floor Anti-Tip Brackets JnstaJJation with the back and side edges positioned exactly where the back and sides of range will be located To reduce the risk of tipping of the range, when installed.
  • Page 10 UN INSTALLATEUR QUALiF[I_ DOlT EFFECTUER L'[NSTALLAT[ON ET LE SERVICE IMPORTANT: CONSERVEZ CES INSTRUCTIONS POUR LES INSPECTEURS LOCAUX. MSEZ CES INSTRUCTIONS ET CONSERVEZ-LES POUR RI_FI_RENCES ULTI_RIEURES. Si Jes instructions de ce manue[ ne sont pas suivies _ Ja [ettre, iJ pourrait en r6suJter incendie ou une...
  • Page 11 Assurez-vous [a tapisserie a proximite Notes importantes a ['insta[[ateur four peut resister a [a chaleur gen_ree par [a 1. Lisez toutes les instructions contenues dans ce feuillet cuisiniere. avant d'installer la cuisiniere, Ne b[oquez pas la circulation d'air a I'orifice 2.
  • Page 12 , Comme sur Jes cuisinieres standard a gaz, AJimentation en gaz - Installation TABLE DE CUISSON DE CET APPAREIL N'EST PAS Cet appareil a ete conqu en usine pour fonctionner AMOVIBLE. Ne tentez pas de I'enlever. gaz naturel avec une pression d'admission de 4"(1 0,16 cm) de colonne...
  • Page 13 Le regulateur est situe tel que montr6 ci-contre. laissez pas le regulateur glisser le tuyau lots du branchement. Figure Emplacement du Figure regulateur Une fois le regulateur en place, ouvrez le robinet de la Branchement du r_gulateur de pression ligne d'alimentation en gaz.
  • Page 14: Conversion Au Gaz Propane

    Dans le cas o@ il n'y a qu'une prise de courant murale Conversion au gaz propane bipolaire standard, il incombe au client de la remplacer Cet appareil fonctiorme au gaz nature! ou au gaz par une prise de courant murale tripolaire correctement propane.
  • Page 15 4. Installez I'appareil dans I'armoire tel que decrit a la lnstaliation de ia cuisiniere section prec6dente. Installation Standard Installation avec un dosseret 1. La table de cuisson chevauche de chaque c6te du dessus du comptoir et la cuisiniere est assise sur le plancher, La La profondeur du decoupage de 21 3/4"...
  • Page 16 Branchez ['a[imentation en _[ectridt_ 9.5 Fonctionnement et r glage des br leurs et ouvrez [e robinet prindpa[ du four. d'alimentation en gaz 9.5.1 grQleurs a allumage electrique Le fonctionnement des alhmeurs electriques devrait etre 9.3 V_rifiez les allumeurs verifie apres que la cuisiniere et I'arrivee de gaz aient ete verifiees minutieusement pour detecter les fuites et que la...
  • Page 17 9.5.2 BrQieur Mise & niveau de [a cuisiniere fourneau & dapet d'air Mettez [a cuisiniere de niveau et ajustez [a hauteur de [a table de cuisson avant de ['installer darts [e decoupage du comptoir. Insta!lez une grille au centre du four. Deposez un niveau _ bulle sur la grille (voir la figure 13).
  • Page 18 1. Depliez le gabarit de papier et placez-le ;] plat sur le instructions de s cudt importantes plancher, I'endos et les extremit6s des c6tes exactement & I'endroit oO I'arriere et les c6tes de la Pour r_duire le risque de cuisiniere seront places !ors de I'installation (utilisez basculement...
  • Page 19 BAKE VALVE VDLVULA HORNEAR BAKE ION1 {)ETEN{)ELJR CUf_S()N NCENL' HORN ..AL LUkIEUR CU} SOON ELECTRONIC O,/EN TROL CONTROL ELECTRONIC0 HORNO L,£ (}0NIR01E (C!RON (}BE BRC_i[: ,liVe' ASAR LNULU GM I LL,_u BROIL IGNITER ENCEND I DO DBAR ALLUNEUR LLAGE ,nr,,_Q _! ,\N nc oR RkIOBIA/O...
  • Page 20 COOKTOP C RCJ]T/C]RCJITO DE PLANCi IA DE COCINAR/ CIRCUIT TRBiE CU SSON R(_HF RE#R I GN SW TRASERO _'_'(/ DERECHO Bb'/NtR IGNI IN/ER Ai _LJM QUEMAr_)R EN(END SLPERIOR /_RR[ERE DRO] r IIOUG I}" RI I UNAGI URLJI H JR BUR[_R IGNITER QJEMADDb_ K/JEND...

Table of Contents