Table of Contents
Advertisement
Available languages
Available languages
Quick Links
Download this manual
See also:
Use and Care Manual
iNSTALLATiON
AND SERVICE MUST BE PERFORMED BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline
or other flammable
vapors and liquids in
the vicinity
of this or any other appliance.
Cooktop Dimensions
30" Min. *
(76.2 crn)
A
IMPORTANT INSTALLATION INFORMATION
• All electric cooktops run off a single phase, three-wire
or four-wire cable, 240/208 volt, 60 hertz, AC only
electrical supply with ground.
• Minimum distance between cooktop and overhead
cabinetry is 30" (76.2 cm).
Cooktop Cutout
Dimensions
C
4" X 8" (10.2 cm x 20.3 cm)
opening to route armored cable
if a panel is present
* 30" (76.2 cm) min. for unprotected cabinet
24" (61 cm) min. for protected surface
Figure 1
30" Ceramic Model
303A(78,1)
213A(55,2)
3_/8(7,9)
7 (17,8)
28% (72,7)
19_A (48,9)
36" Ceramic Model
3634(93,3)
213A(55,2)
3_/8(7,9)
7 (17,8)
345/8 ( 87,9)
19_A (48,9)
iM'
!N!MM'
30" Ceramic Model
293A (75,6)
30 (76,2)
203/s (51,8)
205/8 ( 52,4)
9 (22,9)
36" Ceramic Model
3534 (90,8)
36 (91,4)
203/8 (51,8)
205/8 ( 52,4)
9 (22,9)
Printed in United States
All dimensions are in inches (cm).
* Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for installation of the junction box on the
wall at the back of the cooktop.
P/N318201444 (0803) Rev.B
English - pages 1-5
Espafi_ol- pages 6-10
Fran_ais - pages 11-15
Notes - 16
Advertisement
Table of Contents
Related Manuals for Electrolux EW30EC55GB1
Summary of Contents for Electrolux EW30EC55GB1
- Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- Page 2 Overhead Cabinet Should Not Exceed a Maximum Deptl_ of 13" (33 cm) .. < Clearance Between the K Min. Recommended _ Top of the Cooking_nceBetwe_ _ ¢,,t_,,t_ Rear Platform and the Bottom Edge of Cutout and of an Unprotected Wood Nearest Combustible 10"...
-
Page 3: Important Safety Instruction
Observe all governing codes and local ordinances. important Notes to the Installer Read all instructions contained in these installation A 3-wire or 4-wire single phase 120/240 or 120/208 Volt, 60 Hz AC only electrical supply is required on a instructions before installing the cooktop. separate circuit fused on both sides of the line (time- Remove all packing material before connecting the delay fuse or circuit breaker is recommended). - Page 4 Electrical Connection You may not ground the cooktop Connect the flexible armored cable that extends from the through the neutral (white) wire if cooktop is used surface unit to the junction box using a suitable strain in a new branch circuit installation (1996 NEC), relief at the point the armored cable enters the junction...
- Page 5 3. Set the cooktop into the countertop cutout. Cooktop Installation 1. Visually inspect the cooktop for damage. Also make NOTE: Do not use caulking compound; cooktop should sure all cooktop screws are tight (see Figure 6). be removable for service when needed. Do not remove the nylon spacers on the edges of the cooktop.
- Page 6 LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almanece ni utilke gasolMa u otros vapores y liquidos mflamables en la proximidad de este o de cualquier otro artefacto.
- Page 7 El armario superior no debe sobrepasar una profundidad m_ixima de 13" (33 cm) k rain. distancia 30" (76.2 cm) min. de espacio recomendada entre el horde trasero del corte y el -'--..L.__.---J entre la parte superior del foagrid _ "_ y la parte inferior de un armario compartimiento de de madera o metal sin protecci6n.
-
Page 8: Nota Importante
Para el suministro el6ctrico solamente se necesita Notas importantes para el instalador Lea todas las instrucciones contenidas en este manual corriente con frecuencia de 60 Hz AC y fase Onica de antes de instalar la estufa. 120/240 o 120/208 voltios suministrada por cable de 3 o de 4 alambres en un circuito separado con fusibles Saque todo el material usado en el embalaje de la estufa en ambos lados de la Iinea (se recomienda un fusible... -
Page 9: Conexion Electrica
Conexion Electrica No podr_ conectar a tierra la cocina Conecte el cable blindado flexible que se extiende desde la a traves del cable neutral (blanco) si la cocina se usa superficie del artefacto hasta la caja de empalmes en una nueva instalaci6n de ramal de circuito (1996 utilizando una grapa de alivio de tensi6n adecuada en el... -
Page 10: Antes De Ilamar
Instalad6n de ia estufa No quite los espaciadores de nil6n 1.Visualmente inspecciones la estufa para dahos. en los bordes de la estufa, Estos espaciadores Verifique adem_s que todos los tornillos de la estufa mantienen la estufa en el centro del espacio est_n bien ajustados (Figura 6). - Page 11 UN INSTALLATEUR QUALIFIE DOlT EFFECTUER L'INSTALLATION ET LE SERVICE. iMPORTANT: CONSERVEZ CES iNSTRUCTiONS POUR LES INSPECTEURS LOCAUX. USEZ CES iNSTRUCTiONS ET CONSERVEZ=LES POUR REFERENCES ULTERIEURES. POUR VOTRE SECURITE: N'entreposez et n'utilisez pas d'essence ou d'autres produits inflammables a proximite de cet appareil ou de tout autre appareil. Dimensions de la plaque de cuisson INSTRUCTIONS DE SECURITE IMPORTANTES...
- Page 12 L'armoire sup_rieure ne doit pas exc_der profondeur maximale de 13" (33 cm). r ioir o, 30" (76.2 cm) entre le haut Distance minimale de la surface de cuisson recommand_e entre _ubaSerdet_'arnm°'rpret_bg°:_ " dm@:_rterlecomretbl_}i_i 1 0 _ 25.4 cm) plus proche du dessus de comptoir.
- Page 13 Installateur Un c_ble @lectrique a 3 ills ou 4 ills monophas@ 120/ 1. Lisez toutes ces instructions avant de proceder 240 ou 120/208 Volt, 60 Hz AC est requis sur un I'installation de la plaque de cuisson. circuit s@par@ muni d'un fusible sur chaque fil 2.
- Page 14 Connexions electriques Vous ne pouvez pas faire la Branchez le c_ble flexible arm_ de I'appareil _ la bo_te de mise _ la terre de I'appareil par le fil neutre (blanc) jonction a I'aide d'une hague anti-traction appropri@e si I'appareil est utilise dans une nouvelle I'endroit o@le c_ble arm@p@n@tre dans la botte de jonction.
- Page 15 3. Ins_rez I'appareil dans la d_coupe de dessus de comp- Installation de ia plaque de cuisson toir. 1.V_rifiez si la plaque de cuisson est endommag_e. Veillez _galement _ ce que toutes les vis de la plaque de cuisson NOTE: N'utilisez pas de pate _ calfeutrage; on dolt pouvoir soient bien serr_es (Figure 6).
- Page 16 NOTES/NOTAS:...