Frigidaire FAZ12HS2AB Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Took Needed
[] Flat=blade and Phillips [] Tape measure
screwdrivers
[] Drilland %2" orsmallerbit
[] Level
Through=the=Wall Installation:
In addition to the tools listed above, the following tools are
needed for through-the-wall installation,
[] Saw [] l"(2.5cm) orthicker
(umber
[] Wood preservative
[] Caulk [] #10 x l" wood screws (7)
Parts Supplied (on some models)
Check that all parts are included in parts package.
C
(
E F
H
G
A. Foam window sash seal
B. Window lock bracket
C. Side curtains (2)
D. Foam seal
D
E. #10x 1//pan-head Phillipsscrews (3)
F. #10x _" round-head screws (6)
G. Top channel
H. #10x ¼" pan-head Phillips screws (3)
IMPORTANT:
Observe all governing codes and ordinances.
Check the location where air conditioner will be installed. Proper
installation is your responsibility, Make sure you have everything
necessary for correct installation.
The location should provide:
[] Grounded electrical outlet within 4 ft (I 22 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
[] Free movement of air in room to be cooled.
[] A large enough opening for the air conditioner,
[] Adequate wallsupportforweighto(airconditioner. Air
conditioner weighs between 70 and 851bs (32 to 40 kg),
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.
A. Cabinet louvers
NOTE: Installation parts are supplied for double-hung windows
up to 36" (91.4 cm) wide. A special Wide Window Kitis available
from your dealer or serv(ce center. See "Accessories."
NOTE: DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE
P/N 2020213A0155
1