Frigidaire FAK107P1V1 Installation Instructions

I tallati i structi
for ider Casement
NOTE:
These instructions describe installation
in a typical wood framed window with a wood
SLIDE-BY sash, or installation in a metal
CASEMENT window. Modification may be
necessary when installing in windows made
differently than those shown in these instructions.
Ahigh window accessory kit EA 103W is available
for window heights up to 62"(1575mm).
TABLE OF CONTENTS
SUBJECT PAGE
Meeting Electrical Requirements 1
Electrical Connection 2
Preparing for Installation 2
Sliding Window Installation 4
Casement Window Installation 5
Installation in Wood Window 6
Meeting Electrical Requirements
OBSERVE ALL LOCAL GOVERNING CODES
AND ORDINANCES.
DO NOT, UNDERANY CIRCUMSTANCES, REMOVE
THE POWERSUPPLYCORDGROUNDINGPRONG.
NOTE: If codes permit, and a separate grounding
wire is used; it is recommended that a qualified
electrician determine that the grounding path is
adequate and not interrupted by plastic, non-metallic
gaskets, orother insulating materials.
RECEPTACLE WIRING
Receptacle wiring should bea minimumof 14gauge.
Use copper wire only. It is your responsibility to
provide proper and adequate receptacle wiring,
installed bya qualified electrician.
ELECTRICAL REQUIREMENTS
A 115 volt (103minimum, 126maximum), 60Hertz,
AC only, 15 ampere fused electrical supply is
required. A time delay fuse or time delay circuit
breaker is also required. A separate circuit, serving
only this appliance, MUSTbe provided.
P/N
ili