Advertisement
Installation
Instructions
[_]
INSTALL THE ANTI-TIP BRACKET
[]
Fold or cut the fl'ont
edge of the template,
along
the
front
guide
line. Place
the template
flush
along
the
front
edge of the cutout
floor,
aligning
the center
line of the template
with the center
line of the
cutout
floor.
Mark
the center
positions
with an awl
or center
punch
for the anti-tip
bracket
location
as shown.
Cutout Floor
[] Remove the template
and drill two holes for the
anti-tip bracket.
g
_/_" Screws(2}
g
[]
Install
the anti-tip
bracket
onto
the cutout
floor
•
/t
,
usmgtwo
_/2 sclews.
[_]
INSTALL SIDE DUCT AND
UPPER DUCT
[] Connect
the side duct to the upper duct as shown.
1. Insert projecting
labs of the upper duct into the
holes of Ihe side duct.
2. Bend the tabs up with caution
as shown.
NOTE:
Remove
any oil or dirt on the surface
of the
microwave oven before the ducLs are attached.
UpperDuct
[]
[]
-J_ L 3Tabs
i1)
(2)
Side Duct
Set the microwave upright,
being careful not to
bend the front flange. Remove the one existing
screw from the left side of the microwave oven.
Peel off the backing
of Ihe double
sided
lape.
Carefully
position
the side duct and upper
duct
assembly
on the microwave
cabinet,
aligning
wida
the bottom
screw hole.
Press down firmly
on the
ducts.
Fasten
the duct assembly
to the left side of
the cabinet
with the screw removed
above.
3
Advertisement
