Installing Or Change The Charcoal Filter; Information - Kenmore 79080372310 Installation Instructions Manual

Installation Instructions
_-_ MOUNT THE MICROWAVE
OVEN (cont.)
[ Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
[] Tighten center
screw completely.
[] Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
NOTE:
The charcoal filter is factot_y installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
Follow these steps to replace or install a charcoal filter.
[] Unplug microwave oven or disconnect power.
%
Open the microwave door and remove the two
vent mounting screws located on top of the
microwave using a #l Phillips screwdriver.
T
[] Slide the vent left and tip forward. Lift out to
remove.
[]Install the charcoal filter. Lay the filter on the back
of the grille with the black mesh face upper.
Tabs Charcoal filter
....... ? _l_ ..... _ _ ..... _ ¢ .... _ _,--_J_ _ _-_
Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
and slide right into place. Replace the two vent
mounting screws located on top of the microwave
using a #l Phillips screwdriver.
T T
Close the microwave door. Plug in microwave
oven or reconnect power.
EN-22