Page 1
LAC7750R_JA3NLLB CAR CD/MP3/WMA Receiver ENGLISH OWNER’S MANUAL MODEL : LAC7750R Please read this instruction booklet carefully and completely before installing, operating or adjusting this product. Auto-CD-/MP3-/WMA-Receiver GERMAN BEDIENUNGSANLEITUNG MODELL : LAC7750R Lesen Sie vor Anschluss, Bedienung und Einstellung dieses Gerätes die Anleitungen bitte sorgfältig und vollständig durch.
ENGLISH Safety note CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT SPLIT COVER(OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with the arrowhead symbol, within an equilateral triangle is intended to alert the user about the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Page 3
Bluetooth ® SIG, Inc. and any use of such marks by LG Electronics is under license. Other trademarks and trade names are those of their respective owners.” Operating condition for using a Bluetooth function - Close windscreen.
MP3/WMA Disc compatibility with this unit is limited as follows: 1. Sampling Frequency / 8 - 48kHz (MP3) 22.05 - 48kHz (WMA) 2. Bit rate / within 8 - 320kbps (include VBR) (MP3) 32 -320kbps (WMA) 3. CD-R/CD-RW file system should be “ISO 9660” 4.
Before use Detaching the control panel You can detach the control panel when leaving the car. When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. 1.
Control panel • Power [PWR] [SOURCE] AUX In [AUX] • Traffic Announcement I I /i i Preset Station [1~6] • Skip / Search [TA] • Seek/ Tune Shuffle [SHF] • Programme Type [PTY] • Auto Store [ Repeat [RPT] • Equalizer [EQ] •...
Battery Installation 1 Remove the battery holder with a sharp product like a ball point pen. 2 Install the battery on the battery holder. 3 Install the battery holder back into its original position. Note • Use only one CR2025 (3V) lithium battery. •...
Connection diagram Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. To Speaker To Vehicle Microphone Plug PHONE MUTE (ORANGE) GROUND(-) (BLACK) DIMMER (PINK) DIMMER SWITCH TO IGNITION (RED) IGNITION SWITCH TO BATTERY(+) (YELLOW) POWER ANTENNA (BLUE)
Page 9
From antenna To the wiring of the vehicle colors of leads. • BLACK: This lead is for the ground connection. • ORANGE: This lead is for the phone line connection. • PINK: This lead is for the dimmer line connection. •...
Basic operation Turning the unit on Press MUTE/PWR (POWER/ on the remote control) or any other button. Note When you insert the CD in the CD slot, the unit turns on. Turning the unit off Press and hold MUTE/PWR and then press and hold MUTE/PWR one more time(POWER/ on the remote control).
Page 11
AF(Alternative frequency) When the reception quality drops, the tuner automatically changes to another station in the network, broadcasting a better reception quality, using the PI and AF codes. ON : wherever you drive, you can continue to listen to the same program without interruptions.
Page 12
DEMO OFF Demo is not displayed on screen. AUX In It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. • Enable : When using a auxiliary equipment. •...
Adjusting the sound level 1 Press SEL (SEL on the remote control) repeatedly to select the mode you want to adjust from volume, bass, middle, treble, balance and fader. The indicator lights up in the following order. VOLUME(VOL) t EQ - USER(BAS, MID, TRB) t BALANCE(BAL) t FADER(FAD) 2 Rotate the MUTE/PWR.
Pairing your unit and Bluetooth phone Pairing links your unit and Bluetooth phone, and is required only once for the initial setup. Before you start the pairing procedure, make sure the Bluetooth feature is turned on in to your Bluetooth phone. Refer to your Bluetooth phone’s user guide. 1 Press B/T to connect your Bluetooth phone.
Page 15
Missed call notification When an incoming call is not answered, the missed call message is displayed on the your screen. 1 The “ ” appears on the screen. 2 Press B/T to place a call. 3 Press i i ( on remote control) to enter the “Received Call”.
Page 16
Disconnecting a Bluetooth phone It is possible to disconnect your Bluetooth phone from this unit. 1 Press B/T and then press U U /AS or u u /PS to select the “Disconnect”. 2 Press i i . The “YES” and “NO” appears on the screen. 3 Press B/T to disconnect a Bluetooth phone from the unit.
Page 17
Search(as preset) stored a call number It is possible to store in preset number from the stored phone number list. 1 Refer to the step 1 - 4 of “Search stored a call number” on page 16. 2 Press i i and then press U U /AS or u u /PS to select the “To preset”. 3 Press i i to storing in preset number.
Note • When you want to make an international call, press i i to add “+”. press I I to delete ” +”. • “+” can only be added when the detail list of Missed call, Dialed call or Received call is selected.
AVRCP Based on the GAP Profile, this uses a Controller (CT) - PDA, computer mobile phone etc., which sends a command to a Target (TG) - TV, discman, headphone etc. The command can be to Play, record, colour control, volume control etc., depending on the nature of the devices involved and the scenario.
RDS operation RDS Display options In normal RDS operation the display will indicate the station name. Pressing DISP enables you to cycle through the various data types in the following sequence: CT t FREQUENCY t PTY t RT t PS •...
To directly play a file, press NUMBER (#) on remote control and then press the track number with 0-9 number. Pause 1 Press B B /X during playback. 2 To return to playback, press B B /X again. Skip to next track/file Press briefly i i ( on the remote control) to select the next track or file.
CD TEXT / ID3 TAG When playing a disc containing information, you can see the CD TEXT/ID3 TAG information. In CD TEXT, information about the disc (disc title, performer and track title) is recorded. In a ID3 TAG, information about the file (album title, Performer name, song title) is recorded. In a WMA Content, information about the file (song title, Performer name) is recorded.
Troubleshooting : Symptom / : Cause The loaded disc is of a type this unit : Correction cannot play. Check what type the disc. Power doesn’t turn on. / The unit doesn’t operate. No sound is heard. / The volume Leads and connectors are not properly level will not rise.