Help? Troubleshooting - Kenwood DDX6054 Instruction Manual

Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
• Cannot set up the subwoofer.
!
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
☞
<Speaker Setup> (page 74)
The Dual zone function is enabled.
☞
<Zone Control> (page 55)
• Cannot select the output destination of the
!
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
☞
<Zone Control> (page 55)
Cannot play audio files.
!
"CD Read" of <Disc Setup> (page 78) is set to
"2".
Cannot Folder select.
!
The Random play function is enabled.
Cannot perform Repeat play.
!
The PBC function is enabled.
• Cannot set up the equalizer.
!
• Cannot set up the crossover network.
The Dual zone function is enabled.
☞
<Zone Control> (page 55)
The DSP Select is Bypass.
☞
<DSP Bypass Control> (page 73)
90
DNX7240BT/DDX6054
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
The Touch Sensor Tone doesn't sound.
?
✔
The preout jack is being used.
☞
The Touch Sensor Tone can't be output from
the preout jack.
Tuner source
Radio reception is poor.
?
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
The specified disc does not play, but another
?
one plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the
number for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
The sound skips when an Audio file is being
?
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
✔
The recording condition is bad.
☞
Record the media again or use another
media.