Adjusting Alarm-Timings; Switching The Alarm On - Silvercrest KH 2236 Operating Instructions Manual

• Select the radio wavelength by me-
ans of the AM/FM wave band selec-
tor f .
• Now select the desired transmitter
through turning the tuning knob
Note:
To improve the reception of transmit-
ters in the FM range slowly move the
end of the wire aerial in various direc-
tions. When you have found the best
reception for the desired transmitter,
fix the wire aerial into this position
e.g. with adhesive tape. For the re-
ception of AM transmitters, an aerial
is built into the appliance. For impro-
ved reception, alter the position of the
appliance in radio mode.

Adjusting Alarm-Timings

If the clock is set correctly, as described
above:
Whilst pressing and holding down the
button ALARM e :
• Press several times in succession,
or simply press and hold the button
HOUR q , to adjust the hour setting.
• Release the button HOUR
as the desired hour setting appears in
the display i .
•
•
s .
The adjusted time will be automatically
accepted as soon as the button ALARM
is released.

Switching the Alarm ON

If the clock and alarm time are set
correctly, as described above:
•
You will be woken by the radio if...
•
You will be woken by the signal tone if...
•
q , as soon
- 7 -
Press several times in succession, or
simply press and hold the button
MIN w , to adjust the minute setting.
Release the button MIN
as the desired minute setting appears
in the display i .
Push the slider switch
tion AUTO. The alarm is now switched
on. For control purposes, a point
appears to the left in the display
the volume controller VOLUME
set to a level high enough to awaken
you.
the volume controller VOLUME
turned down so far that it switches off
with an audible click, i.e. it is in the
position BUZZ.
w as soon
e
o into the posi-
i .
d is
d is