Table of Contents
Advertisement
SET
SET 1
OFF OFF
AM
1
2
3
4
5
6
7
MON TUE WED THU FRI SAT SUN
NO.
NO.
5
SET
SET 2
FRI
CLOCK
PM
6
Press the PROGRAM CANCEL-
ING BUTTON, and cancel the pro-
grammed time. If you press it
again, display returns to the original
state. Press the TIMER ON BUTTON
to finalize the cancellation.
SET 1
SET
OFF OFF
AM
1
2
3
4
5
6
7
MON TUE WED THU FRI SAT SUN
NO.
NO.
5
SET 2
SET
FRI
CLOCK
PM
SET
SET 1
OFF OFF
AM
1
2
3
4
5
6
7
MON TUE WED THU FRI SAT SUN
NO.
NO.
5
SET 2
SET
FRI
CLOCK
PM
In the same procedure, cancel the programmed time
of system off 2.
B. Cancel the whole
7
Press the BUTTON FOR SE-
LECTING DAYS OF A WEEK, and
shift to the day of the week to be
canceled. Then, press the HOLIDAY
SETTING BUTTON; the display
"OFF" appears at the top of the
particular day of the week. The
programmed time is canceled. If
you press the button again, the
display returns to the original state.
SET 1
SET
OFF OFF
1
2
3
4
5
6
7
MON TUE WED THU FRI SAT SUN
NO.
NO.
5
SET
SET 2
FRI
CLOCK
PM
Change the
programmed
ON
OFF
PM
time of
system OFF
ON
OFF
PM
PM
p 1 to 7:00
p.m.
Shift to the
ON
OFF
programmed
PM
time of
ON
OFF
PM
PM
system start
2.
Set the
programmed
ON
OFF
PM
time of
system start 2
ON
OFF
PM
AM PM
to program
cancellation.
Shift the day
ON
OFF
of the week to
Thursday to
ON
OFF
set as a
holiday.
8
Press the PROGRAMMING
START BUTTON. The program
setting is now finished.
Notes) ● Unless the button is pressed within 20
minutes, the display will automatically
revert back to the original state. In this
case, setting contents to the point
where the TIMER ON BUTTON (or
HOLIDAY SETTING BUTTON or
BUTTON FOR COPYING PROGRAM
OF PREVIOUS DAY) is pressed will
only take effect.
● To continue the change/cancellation, do
not press the PROGRAMMING START
BUTTON until all change/cancellation
are completed.
● The operation controlled by timer is
executed even while the program is
being set.
MANUAL OPERATION
(Fig. 6)
This schedule timer enables the operation/stop by
pressing the UNIFIED OPERATION/STOP BUTTON in
addition to the operation controlled by timer (opera-
tion/stop according to the programmed time) at any
time.
Press the UNIFIED OPERATION
BUTTON, and the OPERATION
LAMP turns on.
Press the UNIFIED STOP BUT-
TON, and the OPERATION LAMP is
turned off.
Notes)
● The operation automatically stops according to the
programmed time of system off even during the
manual operation. In the meantime, the operation
starts automatically according to the programmed
time of system start even during the stop of
operation.
● If the unit is used in conjunction with other optional
controllers for centralized control, the OPERATION
LAMP of the unit that is not under operation control
may be turned on or off a few minutes behind
schedule. This shows that the signal is being
exchanged, and does not indicate any failure.
14
Advertisement
Table of Contents
