Related Manuals for Panasonic WV-PS104C
Summary of Contents for Panasonic WV-PS104C
- Page 1 Camera Drive Unit WV-PS104C Before attempting to connect or operate this product, please read these instructions completely...
- Page 2 If you lose the fuse cover the plug must not be used until a replacement TO REDUCE THE RISK OF ELECTRIC SHOCK, cover is obtained. DO NOT REMOVE COVER (OR BACK), NO USER A replacement fuse cover can be purchased from your local Panasonic SERVICEABLE PARTS INSIDE. Dealer. REFER SERVICING TO QUALIFIED SERVICE IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCK- PERSONNEL.
-
Page 3: Table Of Contents
STANDARD ACCESSORIES ................................. 7 PREFACE This simple system is specially designed for surveillance The Panasonic Camera Drive Unit WV-PS104C is specially and security needs at offices, factories, schools, hospitals, designed to drive up to four specified cameras such as the public and residential buildings, etc. -
Page 4: Major Operating Components And Their Functions
MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS POWER Camera Drive Unit WV-PS AUDIO AUDIO AUDIO CAMERA VIDEO AUDIO CAMERA VIDEO CAMERA VIDEO CAMERA VIDEO VD/SYNC VD/SYNC (4V[p-p] 75W) SIGNAL GND q Power On/Off Switch (POWER, ON/OFF) t Audio Output Connector (AUDIO OUT) This switch is used to turn the camera drive unit and The audio signal of the specified camera is provided at connected specified camera power on or off. -
Page 5: Installation
INSTALLATION Mounting in the Rack Fix 4 screws. Fix 4 screws. 1. Loosen and remove four screws on the bottom of the camera drive unit, and remove four rubber feet. 2. Place the rack mounting brackets on both sides of the camera drive unit and tighten the supplied screws. 3. -
Page 6: Connections
• Be sure to connect the specified camera and connection will operate and prevent the camera camera input (1ch) correctly. from functioning. <Basic System> Monior Camera Drive Unit WV-PS104C AUDIO CAMERA VIDEO AUDIO CAMERA VIDEO... - Page 7 1. Connect the coaxial cable between the camera and External VD/SYNC Signal CAMERA IN connector of the camera drive unit. The approximate maximum cable length is as follows: Signal Level The VD/SYNC IN connector accepts the VD or VS synchro- nizing signal for external synchronization.
-
Page 8: Specifications
SPECIFICATIONS Power Source: 220 - 240 V AC 50 Hz Power Consumption: Approx. 72 W 1.0 V[p-p] / 75 Ω, BNC Connector Camera Input: 1.0 V[p-p] / 75 Ω, BNC Connector Video Output: –10 dB / 600 Ω unbalanced, RCA pin jack Audio Output: Camera Power Supply: Regulated current multiplex method (310 mA)