Pc Input Terminals Connection - Panasonic TH-50PH30E Operating Instructions Manual

PC Input Terminals connection

COMPUTER
Notes:
• With regard to the typical PC input signals that are described in the applicable input signals list (see page 47), adjustment
values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight
PC input signal types that are not included in the list.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 768 × 768 dots when the aspect mode is set to "4:3", and 1,024 × 768 dots
when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to
show fi ne detail with suffi cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• Change the "Component/RGB-in select" setting in the "Setup" menu to "Component"
(when Component signal connection) or "RGB" (when RGB signal connection). (see page 36)
Signal Names for Mini D-sub 15P Connector
11 12 13 14 15
10
6 7 8 9
1 2 3 4 5
Pin Layout for PC Input
Terminal
Audio
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter
(if necessary)
Pin No. Signal Name
1 R (P /C )
R R
G (Y)
2
B (P /C )
3
B B
NC (not connected)
4
GND (Ground)
5
Stereo mini plug (M3)
Mini D-sub 15p
RGB
PC cable
(Male)
Pin No. Signal Name
6 GND (Ground)
GND (Ground)
7
GND (Ground)
8
+5 V DC
9
GND (Ground)
10
Connections
(Female)
Pin No. Signal Name
11 NC (not connected)
SDA
12
HD/SYNC
13
VD
14
SCL
15
11