Panasonic Diga DMR-PWT420 Operating Instructions Manual page 20

Getting started
Settings
6
Set "Power Save" to "On", "On Timer" or
"Off", then press [OK].
Power Save in Standby
From
0
• On
§
It will go into the Power Save in Standby
mode.
• On Timer
§
Set the start and stop time and then press
[OK].
• "Power Save in Standby" is activated
when the set time comes.
• Off
It is possible to start quickly from standby
mode. (Quick Start mode)
• If you use Home Network function (
select "Off". This function is not available
with other settings.
"Unit's Display" is fixed to "Automatic" in
§
the Setup menu. (
When "Easy Setting has been completed."
appears, Easy Setting is complete.
• Select "Yes" to proceed to "Easy Network
Setting". ( 21)
• Select "No" to finish the Easy Setting.
20
VQT4E90
Power Save
On
To
6
81),
78)
To stop partway
Press [BACK/RETURN
To restart setup
1 Press [SETUP]. (
2 Select "Auto Setup" in "Tuning", then press
[OK].
3 Select "Yes", then press [OK].
To display the Owner ID information on TV
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
- "00 RET" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control until "01 OID" is displayed on the unit's
display.
3 Press [OK] on the remote control.
The PIN is not displayed.
To confirm that channels have been tuned
correctly
Refer to "Using Channel List". (
To change PIN for parental control
Refer to "PIN Entry". (
To change the region for Channel Sorting
Refer to "Channel Sorting by Region". (
• If tuning is cancelled partway through, it may not be
possible to receive the channels. Restart setup again.
].
18)
24)
82)
73)