Miele DA 3160 EXT Operating And Installation Instructions page 25

= Depth of carcase
appliance
^ The depth of appliance
on the lightshield being used:
– a Lightshield to match existing
kitchen furniture
– b DFB lightshield (optional
accesssory)
– c No lightshield.
This is based on a lightshield which
aligns with the front edge of the
carcase.
If the lightshield is further forward or
back, measurement
adjusted accordingly.
When installing a shelf or partition wall,
the building-in space at the back must
not be less than 180 mm.
If it is less than 180 mm, position the
appliance further back, and reduce
measurement accordingly. The
building-in position can be rectified
later by adjusting the depth.
^ Cut the spacer strip supplied to
measurement
Score along the groove for the
measurement as shown, and
remove the surplus.
minus depth of
depends
will need to be
.
^ Screw the spacer strip to the bottom
of the sides of the housing, flush with
the rear wall.
^ Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
25